Project Example
The Process
From requirements to a ready-to-use demonstration or test vehicle, all from a single source.
Together, we define the requirements for your test vehicle.
In the subsequent process, we handle the creation of the system architecture, circuit diagrams, CAD drawings, and necessary software.
We procure the components for you, handle their functional testing, and integrate the components.
Finally, we perform the system commissioning, including all necessary calibrations and acceptance tests.
Get on board and start demonstrating or testing your product.
Our Solution for an ADAS R&D Vehicle
Flexible mounts for front and rear sensors, with adjustable angle and position.
Programmable power management, with supply values readable via CAN during operation.
Measurement rack in the trunk with cable ducts and terminal blocks for easier expansions.
Remote desktop transmission enables data visualization outside the vehicle.
Pre-installed backup power, CAN, and Ethernet lines.
Waterproof adapter plugs at typical sensor points for easy expansion.
Practical Example
All the points described above were implemented on this vehicle (from minute 17:25) under the direction of the founder and with Verwave's current partner companies.